Juniper TX MATRIX Hardware Manual page 253

Copyright © 2010, Juniper Networks, Inc.
Set the switch on each T-CB faceplate to
12. M/S
Set the switch on each T-CB faceplate to
CHASSIS ID
13.
On an external management device connected to the console or auxiliary port of the
14.
T640-CIP, load the original T640 router configuration. For example:
user@host# load override t640-config.conf
If graceful switchover is enabled in the original T640 router configuration, disable it
15.
as follows:
user@host# delete chassis redundancy graceful-switchover
Issue the
16. commit synchronize
errors:
user@host# commit synchronize
On an external management device connected to the console or auxiliary port of
17.
T640-CIP-0 , reboot the corresponding Routing Engine in the T640 router:
user@host> request system reboot
On an external management device connected to the console or auxiliary port of
18.
, reboot the corresponding Routing Engine in the T640 router:
T640-CIP-1
user@host> request system reboot
Display the status of the SIBs by issuing the
19.
Routing Engine:
user@host> show chassis sibs
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online
Verify that four SIBs are in the
Delete all statements associated with
20.
To review the T640 router configuration changes that were merged into the TX Matrix
router configuration, see "Creating a Configuration File on the T640 Router for
Integration into the Routing Matrix" on page 167.
NOTE: You do not need to replace the rear fan tray with the original one.
Chapter 23: Troubleshooting TX Matrix Hardware Components
.
S
0
command and ensure that there are no synchronization
show chassis sibs
Uptime
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
Online state and one SIB is in the
from the TX Matrix router configuration.
LCC0
.
command on the master
Spare state.
221