Maintaining The Tx Matrix Tx-Sibs - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Related
Documentation

Maintaining the TX Matrix TX-SIBs

Purpose
Action
198
12.0 V
3.3 V bias
8.0 V bias
BUS Revision
FPGA Revision
For more information about using the CLI, see the Junos OS manuals.
TX Matrix Host Subsystem Description on page 25
TX Matrix Host Subsystem LEDs on the Craft Interface on page 37
TX Matrix Craft Interface Overview on page 34
For optimum router performance, verify the status of the TXP-F13 SIBs.
On a regular basis:
Observe the status of the TX-SIBs. Check the LEDs on the TX-SIB faceplate and craft
interface.
Check the status of the TX-SIBs using the CLI. Issue the
scc command. The output is similar to the following:
user@host> show chassis environment sib scc
scc-re0:
--------------------------------------------------------------------------
SIB 0 status:
State
Temperature
Temperature (B)
Power:
GROUND
1.8 V
2.5 V
3.3 V
1.8 V bias
3.3 V bias
5.0 V bias
8.0 V bias
Power (B):
GROUND
1.8 V
2.5 V
3.3 V
1.8 V bias
3.3 V bias
5.0 V bias
8.0 V bias
SIB 1 status:
State
Temperature
Temperature (B)
Power:
GROUND
12253 mV
3306 mV
7721 mV
40
1
show chassis environment sib
Spare
42 degrees C / 107 degrees F
41 degrees C / 105 degrees F
0 mV
1785 mV
2493 mV
3301 mV
1782 mV
3294 mV
4996 mV
7133 mV
0 mV
1794 mV
2495 mV
3291 mV
1787 mV
3296 mV
4998 mV
7775 mV
Online
43 degrees C / 109 degrees F
42 degrees C / 107 degrees F
0 mV
Copyright © 2010, Juniper Networks, Inc.