Hp Jetdirect Security Page - HP Jetdirect 640n Administrator's Manual

Table 8-13 Error messages (continued)
Error Code and Message
84 DHCP LEASE TIMERS
ADJUSTED
F1 TRYING TO CONNECT TO
SERVER
F2 TFTP IN PROGRESS
F3 BOOTP/RARP IN PROGRESS
F4 BOOTP/DHCP IN PROGRESS

HP Jetdirect Security page

If the HP Jetdirect print server supports IPsec, you can print an enhanced Security page from the
HP Jetdirect menu that is accessed through the printer control panel. The following figure shows a
typical Security page:
NOTE: This section describes a typical security page. The actual security page content depends on
the HP Jetdirect product and the firmware version.
To print the
1. On the printer control panel, navigate to the HP Jetdirect menus.
2. In the HP Jetdirect menus, locate and select the
3. In the Security
supported by the print server.)
4. Click Yes
ENWW
Description
The print server detected a DHCP lease error due to one of the following conditions:
●
●
●
●
The HP Jetdirect print server is attempting connection to the NetWare server(s). This
is a normal message. Wait until the connection is established or another status
message appears.
The print server is attempting to use TFTP to obtain TCP/IP configuration settings
over the network.
The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
HP Jetdirect Security Page:
menu, locate and select
to print the security page.
Renew time is less than 30 seconds.
Rebind time is less than 52 seconds.
Rebind time is less than, or equal to, the Renew time.
Lease duration is less than, or equal to, the Rebind time.
Security
Print Sec Page. (This option is displayed only if IPsec is
menu item.
HP Jetdirect Security page 159