Section 5 — Timeline Operations
In Point, Out Point or Slide Point Trim
Slip Trim or Rolling Trim
394
Figure 431
shows the frames and trimming areas around a cut point.
Figure 431. Cut Point Trimming Areas
The trimming mode changes based upon the area in which the cursor is
positioned when a trimming drag begins.
A: Out Point Trim
B: Slide Trim
C: In Point Trim
Note
Click the Preview window after
to the Timeline cursor on the selected track. The mode is determined by the
area (A,B, or C) which is clicked in the Preview window.
For slip or rolling trim, each frame of the cut point is displayed in the
Preview window as illustrated in
Step 1
to select the cut point placed nearest
Figure
432.
EDIUS — User Reference Guide