Aux Monitor Point In Audio Control Panel - GRASS VALLEY MAESTRO 1.5 - RELEASE NOTES Release Note

Version 1.500

Aux Monitor Point in Audio Control Panel

Program
Preset
+3
Aux
+2
Clean Feed
+1
Off-Air
0 VU
-1
Mix 1
-2
-3
Mix 2
-5
-7
-10
Mix 3
-20
Mix 4
Options
ALM
18
The audio control panel allows the operator to select which audio source is
routed to the audio monitors. In addition to the audio sources previously
supported, it is now possible to direct Aux bus audio to the monitors. The
supported audio sources are as follows:
• Program
• Preset
• Clean Feed
• Off-Air (Mon In on Maestro rear panel)
• Aux
• Mix 1, Mix 1 (Pgm), Mix 1 (Pst)
• Mix 2, Mix 2 (Pgm), Mix 2 (Pst)
• Mix 3, Mix 3 (Pgm), Mix 3 (Pst)
• Mix 4, Mix 4 (Pgm), Mix 4 (Pst)
Since there only eight buttons on the left side of the screen to which to
assign possible monitor points, Clean Feed and Off-Air are assigned to the
same soft button. Pressing the small black button to the left toggles between
the two selections.
Monitor Point selections are shown in
Figure 6. Audio Panel - Monitor Point Selection
Aux / Main Stereo
< Source Name >
Main Main Dolby 5.1 Dolby 5.1 D Str D Str Span Fren Span Fren
Ø Ø Ø Ø Ø Ø
L R L R Lf Rf C Lfe Ls Rs Lf Rf C Lfe Ls Rs Lt Rt Lt Rt M M M M
Phase
Balance
Normal < 1.6 dB
Figure
Mix To
Clean
Main Stereo
Feed
Dolby 5.1
Surround
Dolby + 2
ID
Spanish
French
Dolby-E
Group
Channel
Mapping
5.1
Level
+ 2.3 dB
Home
Reset
6.
AUDIO CONTROL
Mix To Mix To
Clean Clean
Feed Feed
ID Amin
1 2 2
Lt-Rt Stereo
Monitor
- 3 4 . 1
d B
Maestro — Release Notes
Mix To
Clean
Feed
P
EMRG
G
BCST
M
P
S
T
Mono
Dim