Table of Contents
Advertisement
Trimming from the Preview Window
EDIUS — User Reference Guide
Trimming by dragging mouse in the Preview window is another available
trimming method. To trim in the Preview window, do the following:
1. Select Mode>Trimming from the Preview window menu bar as shown
in
Figure
430.
Figure 430. Trimming Mode Selection
The Preview window switches from normal mode to trim mode.
2. Click in the In (beginning) or Out (end) point of a clip to trim.
The color of the cut point changes to green or yellow and trimming is
enabled. The yellow cut point is the active cut point.
3. Select the appropriate trim mode button in the Trim window according
to the desired trimming type. See
information on Trim mode buttons.
The trimming mode changes according to the selected In and Out points.
For more information on trimming modes, see the following references:
• Ripple Trim
on page 399
• Split Trim
on page 401
• Slide Trim
on page 403
• Slip Trim
on page 405
• Rolling Trim
on page 406
4. Position the mouse cursor on the Preview window and drag to the right
or to the left when the mouse cursor changes to the appropriate
trimming cursor as explained below in the section titled
Point or Slide Point Trim
5. Trim the clip as desired while monitoring and verifying the trim
operations in the Preview window.
Table 5 on page 388
and
Slip Trim or Rolling
Trimming Clips
for more
In Point, Out
Trim.
393
Advertisement
Table of Contents
