Table of Contents
Advertisement
Section 5 — Timeline Operations
Trimming with Shortcuts
398
To use keyboard shortcuts in trimming operations, do the following:
1. Select Mode>Trimming from the Preview window menu bar as shown
in
Figure
437.
Figure 437. Trimming Mode Selection
The Preview window switches from normal mode to trim mode.
2. Click in the In (beginning) or Out (end) point of a clip to trim.
The color of the cut point changes to green or yellow and trimming is
enabled. The yellow cut point is the active cut point.
Select the appropriate trim mode button in the Trim window according to
the desired trimming type. See
Trim mode buttons.
The trimming mode changes according to the selected In and Out points.
For more information on trimming modes, see the following references:
• Ripple Trim
on page 399
• Split Trim
on page 401
• Slide Trim
on page 403
• Slip Trim
on page 405
• Rolling Trim
on page 406
3. Use theses shortcuts to trim the clip:
• [
] - Trim +1 frame (one frame after the current frame).
.
•
]+[
] - Trim +10 frames (10 frames after the current frame).
[SHIFT
.
• [
] - Trim -1 frame (one frame before the current frame).
,
•
]+[
] - Trim -10 frames (ten frames before the current frame).
[SHIFT
,
Table 5 on page 388
for more information on
EDIUS — User Reference Guide
Advertisement
Table of Contents
