GRASS VALLEY EDIUS VERSION 5.1 User Reference Manual page 230

Section 3 — Capturing and Importing Clips and Stills
230
Note If a reel name was set while defining Input Settings, it will be displayed in the
Batch Capture dialog. See Setting Reel Name
tion.
6. De-select (remove the check mark) any clips you may want to exclude
from the batch capture.
Note As clips are added to the batch capture list, they are automatically selected
for inclusion in the batch capture.
7. Click the
Show Setup Dialog
Refer to Capture Settings
batch capture settings.
8. Click the
Capture
list.
The Batch Capture dialog (see
capture operation in progress.
Figure 213. Batch Capture in Progress
9. While capturing a clip, clicking the
marker at the current timecode location and the message "marker set to
00:00:00;00" (00:00:00;00 is replaced by the actual clip timecode) is
displayed for five seconds. See Sequence and Clip Markers
more information on Clip markers.
Note The total number of Clip markers set during a batch capture operation is also
displayed in the Batch Capture dialog.
10. When the batch capture is complete, click the
Batch Capture dialog.
button to verify the capture settings.
on page 207
for a discussion of appropriate
button to begin capturing the clips in the batch capture
Figure 213
Set Mark
on page 211 for more informa-
for an example) shows the batch
button will place a Clip
on page 316
button to exit the
Close
EDIUS — User Reference Guide
for