Table of Contents
Advertisement
Adjusting Video and Audio In/Out Points
EDIUS — User Reference Guide
Each click of the toggle button selects a different mode and changes the
and
button icon in the Player as follows:
Out
Set Video In
Set Video Out
Set Audio In
Set Audio Out
With In and Out points set separately for video and audio the position bar
in the player is divided horizontally into two sections. The upper (yellow)
section represents the video and the lower (green) section the audio. See
Figure 266
for an example.
Note
If the position bar is not divided, place the mouse cursor at the far right or far
left edge of the position bar. Click the left mouse button while holding down
the [CTRL] key and the position bar is divided.
Figure 266. Split Position Bar for Video and Audio
Alternative Methods:
• Select Marker>Set Audio In or Marker>Set Audio Out from the
Preview window menu bar.
• Press [
] or [
] on the keyboard to set In or Out points respectively.
U
P
Note
When setting In and Out points for either video or audio only, only that
portion of the clip can be placed on the Timeline. If In and Out points are set
for both parts of the clip, both may be placed on the Timeline as a single clip
with separate video and audio In and Out points.
To adjust the In and Out points for video and audio, position the cursor at
the current In or Out point on the video or audio position bar. The cursor
changes to indicate which point will be adjusted as follows:
•
- Video In
•
- Video Out
•
- Audio In
•
- Audio Out
Hold down the left mouse button and drag the cursor on the position bar
in the direction in which you wish to adjust the In or Out point.
Clip Operations
In
271
Advertisement
Table of Contents
