Slip Trim - GRASS VALLEY EDIUS VERSION 5.1 User Reference Manual

Slip Trim

EDIUS — User Reference Guide
Figure 446. Slide Trim to Cursor Position from Clip End
Slip trimming changes the section of the clip to be used without changing
the length or position of the clip. The length and position of neighboring
clips do not change.
When Ripple mode is On, slip trimming is not allowed if there is no margin between the clip
to be trimmed and adjacent clips. When trimming clips with a margin, trimming can only be
done up to the length of the margin.
1. While holding down the [
and end (Out point) of the clip to be trimmed.
The color of the cut point changes to green or yellow and trimming is
enabled. See Figure 447.
Note You may also select the cut points of the clip nearest to the Timeline cursor
on the selected track by clicking the Trim - Select Slip button in the Trim
window.
Figure 447. Slip Trim Clip Select
2. Move the cursor to the cut point.
] key, click on the beginning (In point)
CTRL
Trimming Clips
405