Section 5 — Timeline Operations
404
2. Move the cursor to the cut point.
The cursor changes shape as shown in
3. Drag the cursor to the left or right to trim the clip at the end point.
The length and position of the clips before and after the two clips at the
slide trim cut point are not affected.
Note
You can fine tune trimming by 1-frame or 10-frame units by using the trim
buttons in the trim window or the corresponding keyboard shortcuts. See
Trim Mode Operation Buttons
Figure 445. Slide Trim
Alternative Method:
1. Select the track where the clip to be slide trimmed is placed.
2. Move the Timeline Cursor to the point to which the clip should be
trimmed.
3. Press the appropriate shortcut key to slide trim from the beginning of
the clip to the cursor position or from the end of the clip to the cursor
position:
• [
]+[
]+[
] - Slide trim from the In point side of the clip.
CTRL
ALT
N
• [
]+[
]+[
] - Slide trim from the Out point side of the clip
CTRL
ALT
M
Figure
445.
on page 388
for more details.
EDIUS — User Reference Guide