Memory Scan - Yaesu FTM-400DR Operating Manual

Signal Search
Memory scan
The FTM-400DR/DE transceiver will scan the frequencies registered in the memories in
the order of the memory channel number.
1
Switch to the memory mode
2
Press briefly
The function menu will be displayed.
3
Touch [SCAN]
When [SCAN] is not displayed in the function menu,
Tip
touch [BACK] or [FWD] to switch the menu.
The scanning will start from the lowest to the highest
memory channel number.
During scanning, the decimal point of the frequency
display will blink.
When a signal is received, the scan will stop for three
seconds before starting to scan again.
• The scan can also be started by pressing the [UP] or
Tips
[DWN] button on the microphone for one second or
longer.
• The scanning direction (UP/DOWN) can be set using [SCAN]→[2 SCAN DIRECTION] in the
set-up menu.
• The action to be taken when scanning is stopped can be set using [SCAN]→[3 SCAN
RESUME] in the set-up menu (refer to the previous page).
• The squelch level may be adjusted using the following procedure during scanning.
Touch [SQL] → Turn
● To stop the scanning
To stop the scanning, either touch [SCAN] or press the microphone [PTT] button (the
radio will not transmit in this case).
74