Operation On 60-Meter (5 Mhz) Band (U.s. Version Only) - Yaesu FT-2000 Operating Manual

B O
ASIC PERATION
O
PERATION ON
The FT-2000D includes the capability for transmission and reception on the five spot frequencies assigned to the Ama-
teur Service in the United States. To operate on the 5 MHz band:
1. Press the [ V/M ] button once to enter the "Memory"
mode (a memory channel number "USx" will appear
on the Multi-Display Window in the display.
2. Press the [ M CH ] button. The LED imbedded in the
button will glow red to signify that rotation of the [ SUB
VFO-B ] knob will allow selection the memory chan-
nel.
A :
If the memory channel selection seems not to be oper-
ating, check see if the orange lamp to the right of the
[ SUB VFO-B ] knob is illuminated. If so, pressing the
[ A/B ] button will cause the orange lamp to the right of
the [ SUB VFO-B ] knob to go out. Now, press the [ M
CH ] button to begin memory channel selection.
3. Memory channels "US1" through "US5" are pre-pro-
grammed, at the factory, with the permitted frequen-
cies in the 5 MHz band, and the USB mode is auto-
matically selected on these channels.
4. To exit from 60-meter operation and return to the VFO
mode, just press the [ V/M ] button.
N :
The frequencies and operating mode for 5 MHz band op-
eration are both fixed, and may not be changed.
Page 38
:
R
ECEIVING ON
60-M 5 MH
ETER
A
MATEUR
B
Z AND U.S.
Main Tuning Dial Knob
FT-2000D O
B
ANDS
[ M CH ] Button
[ V/M ] Button
[ SUB VFO-B ] Knob
[ A/B ] Button
M