Table of Contents
Advertisement
7.
Punch registration loop adjustment
(PK-1 only)
Adjusting the registration loop amount.
Step
1
Enter the 36 mode.
2
[36 Mode Menu Screen]
Press "
Finisher adjustment."
6
3
[Finisher adjustment mode menu
Screen]
Press "
Punch adjustment."
5
4
[Punch adjustment mode menu
Screen]
Press "
Punch regist loop adjustment.".
3
5
[Punch regist loop adj. Screen]
Press the
NEXT ADJUSTMENT
PREVIOUS ADJUSTMENT
"reverse" or "ADU".
6
Set paper in the tray, set originals on
RADF , and press the Start button.
7
Check the registration loop amount.
8
If the registration loop amount is not
appropriate, press the C button while
pressing the button.
9
Enter a value with numeric keys and
press the
SET
Setting range: -20 to +20
1 step=0.8 mm
10
Repeat steps 5-9 until the registration
loop amount is appropriate.
11
Press the
PREVIOUS SCREEN
turn to the Punch adjustment mode menu
Screen.
Operation
or
key to select
key.
key to re-
1 - 83
[18] List Output Mode
Outputing various data.
1.
Select "
List output mode" in the 36 Mode Menu
7
Screen to display the List output mode menu
Screen.
2.
List output mode menu consists of the following:
Machine management list 1
1
Adjustment data list
2
Machine management list 2
3
Parameter list
4
Memory dump list
5
Font pattern
6
3.
Press the number button corresponding to the item
to adjust.
The output setting screen for the selected item
appears.
4.
The List Output Mode Menu Screen reappears
after each list is output.
5.
Press the
PREVIOUS SCREEN
put mode menu Screen to return to 36 Mode Menu
Screen.
Note:
List output screen is not displayed for
Machine management list 2 and
3
subsequent items unless address 30-1
is set to 1 with
in 25 mode.
36 ADJUSTMENT
key in the List out-
software SW setting
1
Advertisement
Table of Contents
