Minolta DI750 - MANUAL SERVICE Service Manual page 25

ADJUSTMENT
32 Finisher Stapling and folding stopper adjustment (FN-4 only)
adjust-
Folding stopper adjustment (FN-4 only)
33
ment
34 Cover sheet tray size adjustment (Cover Inserter A only)
35 Trimmer stopper adjustment (TMG-1only)
36 Centering adjustment
37 Paper up/down plate horizontal adjustment
38 Skew adjustment
39 Tray Spring Pressure Adjustment
40 Paper Feed Height (Upper Limit) Adjustment
41 Pick-up Release Amount Adjustment
42 Alignment with pickup unit
43 AC and DC drawer positioning
44 ADU gate gap adjustment
45 RADF Mountng Position Adjustment
46 RADF Hinge Spring Pressure Adjustment
47 RADF Skew Adjustment
48 Drum count reset
* When adjustments must be made in order of precedence, numbers will be shown in circles.
Cautions: Printer control board replacement precautions
• When a damaged image control board is replaced, the memory board on this board must be used on
the new image control board.
Only when the memory board is also damaged, use a new memory board on a new control board.
Since the new memory board does not have adjustment data, the above adjustments are required.
Before making the above adjustments, make the "47-92(output)" setting to make the new memory
board effective.
• After making any adjustment, make the "47mode-96(output ) setting" . After made the "47mode-
96(output )" setting, the adjustment data is saved.
• However, the "47mode -92" and -96" settings are protected to prevent them from careless operation.
In order to make "47mode -92" and -96" settings using the saved adjustment data, the protection
must be disabled. For the unprotection method, contact the service manager of the authorized dis-
tributor.
1-80
1-80
36
1-81
1-81
1-98
1-101
1-105
1-108
1-109
1-112
1-114
1-118
1-115
25 1-31~32
1 - 4