Radf Paper Skew Adjustment - Minolta DI750 - MANUAL SERVICE Service Manual

OTHER ADJUSTMENT

[10] RADF Paper Skew Adjustment

1. Face (side 1) of original paper skew
Note: Always perform this adjustment after
completing the RADF skew adjust-
ment. (Refer to the previuos page.)
Upwards
Downwards
Registration
roller
Step
1 Make a copy in the single sided to single
sided copy mode, then check the skew
of the original. (Either pattern A or B)
Copy paper feed
direction
Copy paper
2 Open the open/close cover.
3 Loosen the retaining screw to release the
registration pulley bracket.
Screw
Registration pulley bracket
open/close
cover
Operation
Image
Paper skew Paper skew
pattern B
pattern A
Step
4 Move the registration pulley bracket one
calibration in the direction below
according to the paper skew pattern.
For skew in pattern A:
For skew in pattern B:
Note:
5 Repeat steps 2 to 4 until the original
skew is whithin specified range (0.5% or
less)
Specified range: Paper skew ±0.5% or less
(Paper skew in the paper feed direction)
1 - 116
Operation
Move the registration pulley
bracket downwards (direction
down with original feed flow).
Move the registration pulley
bracket upwards (direction up
towards original feed flow).
Make sure that the registration
pulley shaft does not touch the
open/close cover spring holder
unit.