Table of Contents
Advertisement
Groove
Plate
(8) Tighten the 4 clincher screws to fasten the
clincher into place.
(9) Rotate the stapler gears back upwards, and
remove the jig.
Caution:
When removing the jig, be careful
not to break the miler of the clincher
unit.
(10) Remove the plate from the cartridge and set it
back into the jig.
(11) Reinstall the cartridge and check that stapler
operates correctly.
[28] FNS Adjusting the Angle of the
Folding Stopper (FN-4 only)
1. Tool used
• Screwdriver (Phillips)
2. Preparation
(1) If the staple orientation is not parallel with the
paper edge, adjust as described below.
3.
Adjustment Procedure
(1) Open the front cover and pull the stacker/stapler
Stapler
unit part of the way out.
(2) Remove the 2 rail-stopper screws. Then pull the
stacker/stapler unit all of the way out.
Rail Stopper Screw
1 - 135
OTHER ADJUSTMENT
Stacker/Stapler Unit
Rail Stopper Screw
Advertisement
Table of Contents
