Table of Contents
Advertisement
[19] FNS Adjusting the Paper Exit-
Opening Solenoid
1. Tools used
• Phillips-head screwdriver
• Scale
2. Preparation
(1) Remove the following parts.
• Rear cover
• Top cover
• Cover Inserter A (if installed)
(2) With SD4 (paper exit-opening solenoid) ON,
measure the gap between the solenoid plunger
and the bracket stopper.
Spec value for gap: A = 6.0 ±0.5mm
SD4 (Exit Opening)
(3) If the gap is out of spec, carry out adjustment
describe as follows.
3. Adjustment Procedure
(1) Remove the 2 set screws holding the solenoid
bracket in place, and remove the solenoid to-
gether with the bracket.
(2) Loosen the 2 screws holding the solenoid to the
bracket, and adjust the position of solenoid.
(3) Retighten the 2 solenoid screws, then replace the
solenoid and bracket into their original position
and screw in the 2 bracket screws.
(4) Reassemble in the opposite sequence to re-
moval.
1 - 127
OTHER ADJUSTMENT
Solenoid Bracket
Screws
Solenoid Bracket
Screws
Advertisement
Table of Contents
