Table of Contents
Advertisement
OTHER ADJUSTMENT
[25] FNS Adjusting the Tension of the
Lower-Alignment-Plate Drive Timing
Belt (FN-4 only)
1. Tool used
• Screwdriver (Phillips)
2. Preparation
(1) If the lower-alignment-plate drive belt tensioner
has been loosened as a result of belt replace-
ment or for some other reason, adjust as de-
scribed below.
3. Adjustment Procedure
(1) Loosen the 2 set screws (see illustration).
(2) Move the belt tensioner so that the end is aligned
with the center mark on the scale, and retighten
the screws.
Belt Tensioner
Scale
Screws
[26] FNS Adjusting the Stapling Position
(Flat Stapling)
1. Tools used
• Screwdriver (Phillips)
• Scale
2. Preparation
(1) Check whether the virtual line running between
the stoppers is parallel to the virtual line between
the staplers.
(2) If the lines are not parallel or if you need to change
the stapling position, carry out adjustment as
described below.
1 - 132
Staple Positions
Flat-Stapling Stoppers
Advertisement
Table of Contents
