Table of Contents
Advertisement
8. Watching the graduations provided in the drawer,
move the edge guide in the rear.
• If the difference is greater than the specified
value, move the edge guide toward the front.
• If the difference is smaller than the specified
value, move the edge guide toward the rear.
9. Load paper and print another test page to check
the difference between widths B and C.
* Make adjustments until the difference falls within
the specified range.
10. Tighten the screws which has been loosened in
step 7.
* Adjust "Tray 5" using the same steps.
11. Touch "Close".
<Leading Edge Adjustment for Duplex Printing>
1. Touch "Left ADJ Duplex"
2. Press the [Start] key.
A test print will be produced.
3. Measure widths B and C of the pattern on the test
printout, and check that the difference is within
the specified range.
Specifications: Width B - Width C = 0 ± 1.0 mm
4. If the difference between the measured widths B
and C is outside the specified range, enter the
correction value using the
Adjustable range: -3.0 to +3.0 mm
(Step: 0.2 mm).
C
5. Print a test page again, and check if the differ-
ence is within the specified range.
* Adjust "Tray 5" using the same steps.
6. Touch "Close" twice.
7. Touch "Close" on the Service Mode screen.
A0XWMXC019MA
"Tray 4".
or
key.
Paper exit
direction
B
A3EWPCA009AA
E-13
8. Turn ON/OFF the Power Switch.
Note:
If Service Mode was displayed, you must turn off
the power after exiting Service Mode, and turn it
back on after 10 or more seconds have passed.
XXIII. List output
1. Load tray 2 with A4 or Letter size papers.
2. Press the [Utility/Counter] key.
3. Touch "User Settings"
Reports".
4. Touch "Configuration Page"
Verify that the list is printed.
5. Print other lists (information) as necessary.
6. Touch "Close" three times.
XXIV. Connecting cables
1. Connect the network cable to the machine and
route the cable as shown in the illustration.
Note:
Fit the cable into the hooks.
2. Connect the networking equipment (HUB) using
the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
"Print Settings"
"Print
"Print"
"OK".
A3EW11A020AA
Advertisement
Table of Contents
