Table of Contents
Advertisement
OTHER ADJUSTMENT
[34] TU Trimming Parallelism Adjustment
1. Tools
• Screwdriver (Phillips)
2.
Adjustment Method
Front door
Mark
Screws
Step
1
Measure the lengths of the upper edge (A)
and lower edge (B) of the trimmed booklet
to obtain the parallelism.
Parallelism = A - B
Folding edge
2
Open the front door.
3
Raise the press release lever.
4
Loosen the two screws.
5
Adjust the conveyance guide plate assem-
bly according to the mark so that the paral-
lelism is within the spec.
Standard: less than ±1 mm
6
Tighten the two screws securely.
Press release lever
Conveyance guide
plate assembly
Operation
A
Trim edge
B
1 - 140
Advertisement
Table of Contents
