Table of Contents
Advertisement
[24] FNS Adjusting the Mount Location
of the Lower Alignment Plates (FN-4
only)
1. Tool used
• Phillips-head screwdriver
2. Preparation
(1) Open the front cover and pull out the stacker/
stapler unit.
3. Adjustment Procedure
(1) Move the lower alignment plates into home posi-
tion. (Move so that the actuator on the lower-
alignment-plate drive belt is at PS24 (lower-
alignment-plate HP).
Actuator
PS24
(Lower Alignment Plate HP)
(2) Loosen the 2 set screws fixing the lower align-
ment plates in place (one screw on each plate),
and adjust the plates so that distances A and B
are within specification.
Spec values: A = 337±0.5mm
(3) Retighten the screws.
1 - 131
OTHER ADJUSTMENT
B = 40.4±0.5mm
Screws
Rear Panel
2.0mm
337–0.5mm
40.4–0.5mm
Advertisement
Table of Contents
