Skew Adjustment - Minolta DI750 - MANUAL SERVICE Service Manual

[4] Skew Adjustment

Caution: Tilt adjustment must be performed
when the paper supplied from the cur-
rent tray is different from the paper
supplied from other trays in the way
they are skewed. However, since tilt
of paper supplied from all trays is cor-
rected in the second paper feed unit,
this adjustment have little effect.
1. Tool
• Screwdriver (Phillips)
2. Adjustment of angle of conveyance
roller of tray 1/2/3
Bearing fixing plate
Screws
a. Adjustment method
Step
1 Draw out the tray and detach the front
cover.
2 Loosen the two screws to slide the
bearing fixing plate.
3 Secure the fixing plate by tightening the
two screws.
4 Install the front cover and set the tray.
Operation
1 - 105
3. LCT Skew Adjustment
a. Adjustment Method (when All Printed Sheets
are Skewed)
Step Operation
1 Print a test pattern (No.16) in the con-
tinuous copy mode to check for skew.
2 Open the jam access door of the LCT
and adjust the installation position of the
positioning bracket on the bottom plate.
Positioning
bracket
OTHER ADJUSTMENT
Screws