Table of Contents
Advertisement
3. Adjustment Procedure
(1) Loosen the 3 set screws holding the flat-stapling
stopper bracket in place, and position the bracket
so that distance A is within the specification
range.
Spec range: A = 5.5 to 11.5mm
(initial value = 8.5mm)
(2) Hold paper against the stoppers and confirm that
all three stoppers are in alignment.
(3) Execute stapling to confirm that the stopper line
and stapler line are parallel.
Adjust.
Scale
Scale
Scale
1 - 133
[27] FNS Adjusting the Stapler Vertical
Positioning
1. Tools used
• Phillips-head screwdriver
• Jig
2. Preparation
(1) When replacing or reinstalling a stapler or clincher,
adjust the vertical alignment as described below.
3.
Adjustment Procedure
(1) If installing a stapler, mount the stapler into place.
(2) Loosely fasten the clincher in place with 4 screws.
(If the clincher is already fastened in place, loosen
the 4 screws so that you can adjust it.)
(3) Remove the plate from the jig.
Plate
Jig
OTHER ADJUSTMENT
Jig positioning
section
Guide pins
Advertisement
Table of Contents
