Table of Contents
Advertisement
OTHER ADJUSTMENT
[18] FNS Adjusting Opening/Closing at
the Paper Exit
1. Tool used
• Screwdriver (Philips)
2. Preparation
(1) Remove the following parts.
• Rear cover
• Top cover
• Cover Inserter A (if installed)
(2) Switch the power OFF
the paper exit closed, confirm that the paper exit
casing is firmly against the stopper section.
Stopper Section
Paper Exit Opening
(3) If the casing is not in firm contact with the stopper,
carry out adjustment described as follows.
ON
OFF. Then, with
Casing
1 - 126
3. Adjustment Procedure
(1) Loosen the set screw holding the PS12 (paper
exit-opening detector) bracket in place, and ad-
just the bracket position as necessary.
Bracket
Screw
(2) Retighten the bracket set screw.
(3) Reassemble in the opposite sequence to re-
moval.
Advertisement
Table of Contents
