Table of Contents
Advertisement
OTHER ADJUSTMENT
OTHER ADJUSTMENTS
[1] Centering Adjustment
Caution: Centering adjustment need not be
performed normally because paper
inclination is detected in the second
paper feed section and original image
is corrected in the image processing
unit to fit an inclined paper. Centering
adjustment is required only when the
detected paper inclination is not within
the automatic image correction range.
1.
Tool
• Screwdriver (Phillips)
2.
Tray 1/2/3 centering adjustment
Guide plate
a.
Screws
1 - 98
Adjustment method
Step
Operation
1
Draw out the tray.
2
Loosen the two screws at the center of
the tray.
3
Slide the guide plate to adjust the center
position.
4
Tighten the two screws securely.
5
Insert the tray and make a copy to check
the result.
6
Perform steps 1-5 repeatedly until mis-
centering is included in the automatic
adjustment range (±3 mm).
Caution: Disable the mis-centering
correction function by setting
the dip switch 12-3 and confirm
it. Confirm it using the internal
pattern No.16.(Enter 1 to set to
ON)
Standard value of mis-centering: ±3 mm
±3 mm
Image center
Paper center
Advertisement
Table of Contents
