Fns Adjusting The Mount Location Of The Paper Exit Arm; Fns Adjusting The Mount Location Of The Upper Alignment Plates - Minolta DI750 - MANUAL SERVICE Service Manual

[21] FNS Adjusting the Mount Location
of the Paper Exit Arm
1. Tools used
• Screwdriver (Phillips)
2. Adjustment Procedure
(1) Remove the screw to remove the belt detection
gear.
(2) When the stacker paper exit arm is at the position
shown below, secure the belt detection gear with
a screw with the actuator end face of the belt
detection gear aligned with the bottom of the
square hole.
Actuator end face
Belt detection
Stacker paper exit arm
Screw
Bottom of
square hole
1 - 129
[22] FNS Adjusting the Mount Location
of the Upper Alignment Plates
1. Tools used
• Screwdriver (Phillips)
• Scale
2. Preparation
(1) Open the front cover and pull out the stacker/
stapler unit.
3. Adjustment Procedure
(1) Move the upper alignment plates into home posi-
tion. (Move so that the actuator on the upper-
alignment-plate drive belt is at PS8 (upper-align-
ment-plate HP).
Actuator
OTHER ADJUSTMENT
PS8
(Upper Alignment Plate HP)