Table of Contents
Advertisement
ERROR CODE LIST
Warning
Classification
code
Drive
F13-01
F13-02
F13-03
Tray 1
F18-10
F18-11
F18-12
F18-13
Causes
A trouble detection signal is detected
two consecutive times (the first signal
is ignored) in 4 seconds after turning
ON of M4 (paper feed).
A trouble detection signal is detected
two consecutive times (the first signal
is ignored) in 2 seconds after turning
ON of M101 (LT paper feed).
An M6 trouble detection signal (blown
fuse) is detected when M6 (loop
roller) is ON.
An M19 trouble detection signal is
detected when M19 (up drive 1) is
ON.
PS20 (tray upper limit 1) which has
been OFF is not turned ON within 10
seconds of upward movement
started by turning ON of M19 (up
drive 1). At this time, a trouble
detection signal (24V off) is detected.
PS20 (tray upper limit 1) which has
been OFF is not turned ON within 10
seconds of upward movement started
by turning ON of M19 (up drive 1). At
this time, a trouble detection signal
(blown fuse) is detected.
PS20 (tray upper limit 1) which has
been OFF is not turned ON within 10
seconds of upward movement
started by turning ON of M19 (up
drive 1). At this time, no trouble
detection signal is detected.
4 - 43
ERROR CODE LIST
Operation in case of
Estimated abnormal
warning occurrence
The machine stops
M4 (paper feed)
immediately and RL1
PRCB (printer
(main) is turned OFF.
control board)
M101 (LT paper
feed)
LTDB (LT drive
board)
If there is a paper in
M6 (loop roller )
copying
process
DCDB (DC drive
when this trouble oc-
board)
curs, the machine
stops after comple-
tion of copied paper
ejection. RL1 (main)
is turned OFF.
The machine stops
M19 (up drive 1)
immediately and RL1
DCDB (DC drive
(main) is turned OFF.
board)
Error code is not dis-
PRCB (printer
played on operation
control board)
panel. It is displayed
PS20 (tray upper
only on data collec-
limit 1)
tion, list output. Mes-
sage "Please load
paper in tray 1." is
displayed on opera-
tion panel because
tray has not com-
pleted ascending.
parts
Advertisement
Table of Contents
