Wms Offload Utilizing Awms Gui - Dell PowerConnect W-Airwave Manual

This will push a set of commands via SSH to all Dell PowerConnect local Controllers. AWMS must
have read/write access to the controllers in order to push these commands. See Device Setup
Communication Section below for help configuring your device credentials.
Note : This process will not reboot your controllers
Warning : If you don't follow the above steps local controllers will not be configured to populate statistics. This
decreases AWMS' capability to trend client signal information and to properly locate devices. See Appendix A on how
to utilize the Dell PowerConnect W AirWave CLI to enable stats on Dell PowerConnect W infrastructure.
Note : If your credentials are invalid or the changes are not applied to the controller, error messages will display on the
controller's Device > Monitoring page under the Recent Events section. If the change fail, AWMS does not audit these
setting (display mismatches) and you will need to apply to the controller by hand, see Appendix A for detailed
instructions.
Commands Pushed by AWMS during Enable Stats
(Do not enter these commands)
configure terminal
no mobility-manager <Active WMS IP Address>
wms
general collect-stats enable
stats-update-interval 120
show wms general
write mem

WMS Offload Utilizing AWMS GUI

To Offload WMS on the Dell PowerConnect W controllers:
Navigate to Groups>Basic page
Locate the Dell PowerConnect W section
Enable Offload Dell PowerConnect W WMS Database
Locate the Configuration section
Enable or Disable Allow WMS Offload Configuration in Monitor-Only Mode
Click Save and Apply
Figure 10 Offload WMS