Ricoh Aficio 2022 User Manual page 618

Appendix
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you place an original larger than A3, 11"×17" on the exposure glass, only an
A3, 11"×17" area is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the ADF, a
margin of 3 mm (0.1") around each edge of the original may not be sent.
❒ If the receiver uses paper of a smaller width than the original, the image will
be reduced to fit that paper. See p.74 "Auto Reduce".
❒ The machine detects paper sizes in the following ways:
• When you place an original in the ADF, an original wider than about 264
mm (10.4") is scanned as A3, 11"×17" size and an original narrower than
about 264 mm (10.4") is scanned as B4 JIS.
An original narrower than about 230 mm (9.1") will be sent as 8
1
8 /
2
Originals up to 1,200 mm (47.2") in length can be scanned.
• Refer to the table below for sizes the machine can detect when you place
an original on the exposure glass. Because the machine scans non-standard
size documents in a standard size, part of the image may be truncated de-
pending on the length of the document. For details about how to set non-
standard size documents, see p.16 "Setting a Scan Area", Facsimile Refer-
ence <Basic Features>.
❖ ❖ ❖ ❖ Metric Version
Width
11
❖ ❖ ❖ ❖ Inch Version
Width
*1
Normally a length of about 420 mm (16.5") can be scanned; however, it is only possi-
ble to specify a scanning size up to 432 mm (17").
200
"×14" size.
∼245mm
∼245mm
not detect-
ed
245∼270 B5 JISK
mm
270mm∼ A4K
∼9.6"
9.6"∼10.6"
10.6"∼
*1
Length
245∼270mm 270∼319mm 319∼344mm 344mm∼
B5 JISL A4L
not detect- not detect-
ed ed
not detect- not detect-
ed ed
*1
Length
∼12.5"
12.5"∼13.5"
1 1
8 / "×11"L 8 /
2 2
8"×10"K not detected
not detected
1
8 / "×11"K
2
1
/
2
1 1
8 / "×13"L 8 /
2
not detect- B4 JISL
ed
not detect- A3L
ed
13.5"∼
1
"×13"L 8 / "×14"L
2
10"×14"L
11"×17"L
"×11" or
"×14"L
2