Ricoh Aficio 2022 User Manual page 1090

UNIX Configuration
G G G G
Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the { { { { RETURN} } } } ({ { { { ENTER} } } } ) key. Enter
a new name if you want to use a different one.
1
Note
❒ The host name entered in step
H H H H
Set the print option.
Enter remote printer name [default lp]:
• Press the { { { { RETURN} } } } ({ { { { ENTER} } } } ) key, and printing with PCL or PostScript 3
is enabled.
• If you want to set the device option, enter the option parameter.
Enter remote printer name [default lp]:tray=tray1
Reference
For more information about the device option, see p.19 "Specifying the
Device Option".
• If you enter "text", text printing is enabled.
If you enter "text", printing with PCL and PostScript 3 is disabled.
Enter remote printer name [default lp]:text
Limitation
❒ You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red
Hat Linux 7.0, and 51 for Red Hat Linux 6.2.
❒ When printing with the "lp" command, use "_" instead of "=" and ";" in-
stead of "," for operating systems that cannot use "=" and "," such as So-
laris 2.5 or later.
After setup with the installation shell script is complete, and if you entered
the IP address in step
hosts file is modified
I I I I
Do a test print to make sure that the settings are correct.
# lpr -Pnp file_name
# lp -dnp file_name
Reference
For more information about the "lpr" and "lp" commands, see p.14 "Print-
ing Methods".
8
F
followed by "_prn" appears in "default".
E
, the following message appears: