Ricoh Aficio 2022 User Manual page 992

Appendix
❖ ❖ ❖ ❖ Protocol configuration
To change protocol settings, use
the following command. You can
specify the setting for "lpr", "ipp"
or "smb".
• lpr
msh> spoolsw lpr {on |
off}|msh> spoolsw lpr
{on | off}
• ipp
msh> spoolsw ipp {on |
off}|msh> spoolsw ipp
{on | off}
• smb
msh> spoolsw smb {on |
off}|msh> spoolsw smb
{on | off}
Changing the host name
Use the "hostname" command to
change the printer name.
msh> hostname interface_name
printer_name
Interface name
ether
9
*2
wlan
*3
ip1394
*1
If you did not enter the interface
name, it will be automatically set to
the Ethernet interface.
*2
Available when the optional 802.11b
interface kit is installed.
*3
Available when the optional 1394 in-
terface board is installed.
Note
❒ Enter the printer name using up to
15 characters.
❒ You cannot use a printer name
starting with "RNP" or "rnp".
❒ The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
104
Interface to be config-
ured
*1
Ethernet interface
IEEE 802.11b interface
IEEE 1394 interface
WINS
Use the "wins" command to configure
WINS server settings.
❖ ❖ ❖ ❖ Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
msh> wins
W I N S C o n f i g u r a t i o n :
interface_name: WINS: On
primary server 0.0.0.0
secondary server 0.0.0.0
ScopeID
Current configuration:
primary server 0.0.0.0
secondary server 0.0.0.0
hostname host_name Sco-
peID
Note
❒ If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖ ❖ ❖ ❖ Configuration
Use the "set" command to make
WINS active or inactive.
msh> wins interface_name
{on | off}
• "on" means active; "off" means
inactive.
❖ ❖ ❖ ❖ Setting WINS Server Address
You can make settings for the
WINS server address.
msh> wins interface_name
{ p r i m a r y | s e c o n d a r y } |
IP_address
• "primary" is for setting the pri-
mary WINS server address.
• "secondary" is for setting the
secondary WINS server ad-
dress.