After Executing The Installation Shell Script - Ricoh Aficio 2022 User Manual

Deleting the printer
To print using the "lp" or "lpr" commands, the option specified when the instal-
lation shell script is executed is used. Change the option in accordance with the
workstation you are using.
❖ ❖ ❖ ❖ BSD UNIX workstation, Linux
Delete the printer entry from /etc/printcap, and then execute the installation
shell script again. Select options during the setup process.
Alternatively, search the printer entry from /etc/printcap, and change its
"rp" capability to option setting.
❖ ❖ ❖ ❖ Solaris, HP-UX
Delete the printer entry, and then execute the installation shell script again.
Select options during the setup process. To delete the printer entry, follow the
procedure below:
A
Stop the scheduler.
# /usr/sbin/lpshut
B Delete the printer.
# /usr/sbin/lpadmin -x printer_name
C
Restart the scheduler.
# /usr/lib/lpsched

After Executing the Installation Shell Script

The printing environment is automatically set up when the installation shell
script is executed.
This section describes setup contents when the installation shell script is execut-
ed under Red Hat Linux, Solaris, and HP-UX.
Linux
❖ ❖ ❖ ❖ Adding the IP address and host name to the /etc/hosts file
The following line is added to the /etc/hosts file. The IP address and printer
host name previously entered in the installation script will be used:
192.168.15.16 nphost # Network Printer
• "192.168.15.16" is the IP address, "nphost" is the host name, from # to the
end of the line is the comment.
Note
❒ The /etc/hosts file contains a list of the IP addresses and names of all hosts
communicating on the network. Each entry is delimited with a space or a
tab, and each line is separated with a return.
❒ If you do not use NIS or DNS, you must enter the IP address and host name
of each workstation using the network printer in the /etc/hosts file.
Using the Installation Shell Script
1
9