Ricoh Aficio 2022 User Manual page 1094

UNIX Configuration
Solaris
❖ ❖ ❖ ❖ Adding the IP address and host name to the /etc/hosts file
The following line is added to the /etc/hosts file. The IP address and printer
1
host name previously entered in the installation script will be used.
192.168.15.16 nphost # Network Printer
• "192.168.15.16" is the IP address, "nphost" is the host name, from # to the
end of the line is the comment.
Note
❒ The /etc/hosts file contains a list of IP addresses and names of all hosts
communicating on the network. Each entry is delimited with a space or a
tab, and each line is separated with a return.
❒ If you do not use NIS or DNS, you must enter the IP address and host name
of each workstation using the network printer in the /etc/hosts file.
❖ ❖ ❖ ❖ Registering the printer
The installation shell script registers the printer as a remote printer using the
procedure below:
A If your workstation is Solaris 2.5.1, register the print server and print client
to the print service.
# lpsystem -t bsd -R 0 -y " " " " Network Printer" " " " nphost
B
Register the printer as a remote printer.
# lpadmin -p np -s nphost!option -T dump -I any
• "np" is the printer name, "nphost" is the host name. For more informa-
tion about "option", see p.19 "Specifying the Device Option".
"lp" will be assigned if the option is not used.
When printing with the "lp" command, use "_" instead of "=" and ";"
instead of "," for operating systems that cannot use "=" and "," such as
Solaris 2.5 or later.
C If your workstation is Solaris 2.5.1, set the print job to active so it can be put
in the print queue.
/usr/lib/accept np
D
If your workstation is Solaris 2.5.1, set the print job to active to print.
/usr/lib/enable np
12