Storage And Transportation - Peri VARIOKIT VBC Assembly Instructions Manual

Safety instructions
Hydraulic components
Visual inspections are to be carried out
by authorised personnel at regular
intervals.
Qualified personnel are to carry out a
functionality check before every work-
ing cycle or before assembly takes
place.
If any defects are discovered, repairs
are only allowed to be carried out by
qualified personnel.
Hydraulic hoses have an expiry date.
Observe the manufacturer-specific
information.
Do not suspend any objects from the
hydraulic hoses.
Observe the manufacturer-specific in-
formation regarding inspection and
maintenance of the hydraulic unit.
For correct use and disposal of the hy-
draulic oil, observe the manufactur-
er-specific instructions.
Thicken spilled hydraulic oil immediately
with oil binder and mop it up.
■
Wear safety goggles and suitable
protective gloves when working on
the hydraulic system.
■
Avoid contact with hydraulic fluid.
PERI recommends the use of an oil pan
to collect hydraulic oil from the hydrau-
lic unit.
For safe and professional handling of
hydraulic components, observe the
documentation of the respective
manufacturer.
VBC Balanced Cantilever Hydraulic System – Hydraulic System and Standard Cycle
Assembly Instructions
Note
Always switch off the power to the hy-
draulic unit and prevent it from being
switched on again as soon as the mov-
ing procedure involving the climbing
system has been completed.
This safety measure also applies to the
following:
■
Assembly.
■
Maintenance.
■
Repairs.
■
Inspections.
■
Dismantling.
Approval for use is the responsibility of
the operating personnel.
Electrical components
Danger
High electric voltage at the hydraulic
unit!
Death or serious injury can result from
an electric shock.
⇒ Connection only by qualified
personnel.
⇒ Only qualified personnel may carry
out work and repairs on the electrical
components of the systems.
⇒ Only approved, undamaged and test-
ed connecting cables should be
used.
Only operate the hydraulic unit with the
type of current and voltage specified on
the type plate.
Do not suspend any objects from the
electrical lines.

Storage and transportation

Store and transport components in
such a way that no unintentional
change in their position is possible.
Detach lifting accessories and lifting
gear from the lowered components
only if they are in a stable position and
no unintentional change is possible.
Do not drop the components.
Use PERI lifting accessories and lifting
gear and only those load-bearing points
provided on the component.
During the relocation procedure
■
ensure that components are picked
up and set down in such a way that
unintentional falling over, falling apart,
sliding, falling down or rolling is
avoided.
■
no one is allowed to remain under
the suspended load.
Pre-assembled assemblies should al-
ways be guided with ropes when mov-
ing them by crane.
The access areas on the construction
site must be free of obstacles and trip-
ping hazards, as well as being
slip-resistant.
For transportation, the substrate must
have sufficient load-bearing capacity.
Use original PERI storage and transport
systems, e.g. crate pallets, pallets or
stacking devices.
15