Peri VARIOKIT VBC Assembly Instructions Manual page 14

Safety instructions
Drive mode
Take into consideration the permissible
wind speed limit for drive mode.
In drive mode, clamping and crushing
hazards are created by moving
components.
The individuals carrying out the climb-
ing procedure must be fully informed
about all possible hazards.
All persons who are not required to car-
ry out the moving procedure must
leave the danger zones.
Note
Moving the balanced cantilever equip-
ment is only permitted if the brakes are
actuated.
The equipment must always be fitted
with brakes.
14
Maintenance and repairs
The components of the system are to
be inspected before every use to en-
sure that they are in flawless condition.
Only flawless materials may be used.
Have the system checked monthly for
signs of damage by competent persons
who are authorised to give instructions.
Remove any loose concrete residue.
Immediately remove any dirt that im-
pairs functionality.
Remove and replace damaged
components.
In case of overload or damage, stop
work on and under the platforms, de-
termine the cause, set down and re-
place damaged components.
If the maximum permissible wind
speed has been exceeded, tempera-
tures are outside the area of application
or after any extraordinary event has tak-
en place such as a fire or earthquake,
the functionality and load-bearing ca-
pacity of all safety components as well
as the supporting structure must be
checked.
VBC Balanced Cantilever Hydraulic System – Hydraulic System and Standard Cycle
Supporting structure:
■
A visual inspection is to be carried
out by authorised personnel before
initial use.
■
Only PERI original components are
to be used for repairs or
replacement.
■
In the case of overloading or recur-
rent damage, stop work operations
on and under the platforms, deter-
mine the cause and rectify.
Other components:
■
Repairs are carried out by authorised
personnel and the person authorised
to give instructions is to be informed.
■
In the event of frequently recurring
damage, determine the cause and
remedy it.
■
Route hydraulic lines and power ca-
bles in such a way that they cannot
be disconnected or sheared off, and
that they do not pose a tripping
hazard.
Assembly Instructions