Protective Equipment; Regular Inspections; Maintenance Schedule - probst SM-1200 Operating Instructions Manual

9.1.2 Protective equipment

The following protective equipment is required for installation, troubleshooting, maintenance and repair work:
•
Safety shoes safety class S1 or better
• Sturdy work gloves safety category 2231 or better
•
Class F safety goggles
• Acid-resistant work gloves and safety goggles when working on the battery

9.2 Regular inspections

Inspection sticker with next inspection date:
The inspector may only affix the inspection sticker if the
inspection has been carried out successfully.
•
Observe country-specific regulations.
• Observe the inspection dates prescribed by the country.
•
The product may only be released for use after official approval.

9.3 Maintenance schedule

Probst specifies the following inspections and inspection intervals . The operator must comply with
the statutory regulations and safety regulations applicable at the place of use. The intervals apply
to single-shift operation . In the event of heavy use, e.g. in multi-shift operation , the intervals must
be shortened accordingly.
 Check or retighten all fastening screws after 25 operating hours.
Check regularly every 50 operating hours:
1. Check all fastening screws or tighten them to the valid tightening torque.
2. Check the function of all joints, guides, bolts and gear wheels. Readjust or replace if necessary.
EN - 30.30.01.04558 - 00 - 09/24
9 Maintenance
45