Download Print this page

Personal Protective Equipment; Technical Condition - probst SM-1200 Operating Instructions Manual

Advertisement

Available languages

Available languages

CAUTION
Blockage of the vacuum system due to suction of liquid
Risk of injury from falling load!
The lifting device may only be operated under the following conditions:
Ambient temperature +3 to +40 °C.
Maximum relative humidity , non-condensing.
The lifting device must be sufficiently dimensioned for the load case.
Negative list: The product must not be operated under the following conditions:
Use in a potentially explosive environment can lead to an explosion.
The required minimum vacuum cannot be achieved at an ambient pressure of
less than 800 mbar (corresponds approximately to locations above 1,600 m
above sea level).
 If in doubt, consult Probst before commissioning.

2.8 Personal protective equipment

To avoid injury, always wear suitable protective equipment appropriate to the situation .
Observe the notes on protective equipment in the respective chapters as well as country-specific regulations.

2.9 Technical condition

If the product is operated in a defective condition, safety and function are impaired.
Only operate the product in technically perfect original condition.
Adhere to the maintenance schedule (> see Maintenance chapter).
Only use original Probst spare parts .
If the operating behavior changes, check the appliance for faults. Rectify faults
immediately!
If the fault cannot be rectified immediately, take the appliance out of operation
and mark it as faulty.
Do not modify or change the product without authorization.
Do not render safety devices ineffective under any circumstances.
Ensure that the vacuum hoses are not damaged by pointed or sharp-edged ob-
jects.
Probst accepts no liability for the consequences of a change beyond its control.
EN - 30.30.01.04558 - 00 - 09/24
Do not aspirate any liquid.
Observe the pressure gauge and the signal of the warning device.
2 Basic safety instructions
13 / 53

Advertisement

loading
Need help?

Need help?

Do you have a question about the SM-1200 and is the answer not in the manual?

Questions and answers