Debug Platform Udld - Cisco Catalyst Blade Switch 3130 Reference Manual

Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands

debug platform udld

Use the debug platform udld privileged EXEC command to enable debugging of the
platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command
to disable debugging.
Syntax Description
all
error
rpc {events | messages}
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug platform udld command is the same as the no debug platform udld command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-13271-01
debug platform udld [all | error | rpc {events | messages}]
no debug platform udld [all | error | rpc {events | messages}]
(Optional) Display all UDLD debug messages.
(Optional) Display error condition debug messages.
(Optional) Display UDLD remote procedure call (RPC) debug messages.
The keywords have these meanings:
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
events—Display UDLD RPC events.
•
messages—Display UDLD RPC messages.
•
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
debug platform udld
B-65