Debug Platform Udld - Cisco Catalyst 2960-X Command Reference Manual

debug platform udld

debug platform udld
To enable debugging of the platform-dependent UniDirectional Link Detection (UDLD) software, use the
debug platform udld command in privileged EXEC mode. To disable debugging, use the no form of this
command.
debug platform udld [all| error| switch| rpc {events | messages}]
no platform udld [all | error| rpc {events | messages}]
Syntax Description
all
error
rpc {events | messages}
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS 15.0(2)EX
Usage Guidelines
The undebug platform udld command is the same as the no debug platform udld command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, start a session from the stack master by using the session switch-number command in
privileged EXEC mode. Enter the debug command at the command-line prompt of the stack member.
To enable debugging on a stack member without first starting a session on the stack master, use the remote
command switch-number LINE command in privileged EXEC mode.
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
40
(Optional) Displays all UDLD debug messages.
(Optional) Displays error condition debug messages.
(Optional) Displays UDLD remote procedure call (RPC) debug messages. The
keywords have these meanings:
• events—Displays UDLD RPC events.
• messages—Displays UDLD RPC messages.
Modification
This command was introduced.
Layer 2 Commands
OL-29043 -01