Qos Commands - Alcatel OS-LS-6224 User Manual

4
Command Line Interface

QoS Commands

Command
qos
show qos
class-map
show class-map
match
policy-map
class
rate-limit
show policy-map
trust cos-dscp
set
police
qos
aggregate-policer
show qos
aggregate-policer
police aggregate
wrr-queue cos-map Maps Class of Service (CoS) values to a specific egress queue.
priority-queue out
num-of-queues
traffic-shape
show qos interface
478
Table 4-26. QoS Commands
Function
Enables quality of service (QoS) on the device. To disable QoS on
the device, use the no form of this command.
Displays the quality of service (QoS) mode for the device.
Creates or modifies a class map and enters the Class-map
Configuration mode. To delete a class map, use the no form of this
command.
Displays all class maps.
Defines the match criteria for classifying traffic. To delete the
match criteria, use the no form of this command.
Creates a policy map and enters the Policy-map Configuration
mode. To delete a policy map, use the no form of this command.
Defines a traffic classification and enters the Policy-map Class
Configuration mode. To remove a class map from the policy map,
use the no form of this command.
Limits the rate of the incoming traffic.
Displays the policy maps.
Configures the trust state. The trust state determines the source
of the internal DSCP value used by Quality of Service (QoS). To
return to the default configuration, use the no form of this
command.
Sets new values in the IP packet.
Defines the policer for classified traffic. To remove a policer, use
the no form of this command.
Defines the policer parameters that can be applied to multiple
traffic classes within the same policy map. To remove an existing
aggregate policer, use the no form of this command.
Displays the aggregate policer parameter.
Applies an aggregate policer to multiple classes within the same
policy map. To remove an existing aggregate policer from a policy
map, use the no form of this command.
To return to the default configuration, use the no form of this
command.
Configures the number of expedite queues. To return to the
default configuration, use the no form of this command.
Configures the shaper of the egress port/queue. To disable the
shaper, use the no form of this command.
Displays Quality of Service (QoS) information on the interface.
Mode Page
GC 4-479
UE 4-480
GC 4-480
UE 4-481
CMC 4-482
GC 4-483
PMC 4-483
UE 4-484
UE 4-485
PCC 4-486
PCC 4-487
PCC 4-488
GC 4-489
UE 4-491
PCC 4-492
GC 4-492
GC 4-493
IC 4-494
UE 4-495