Alcatel OS-LS-6224 User Manual page 511

Command Usage
Action serviced to a class, so that if an IP packet arrives, the queue is
assigned per DSCP. If a non-IP packet arrives, the queue is assigned per CoS
(VPT).
Example
The following example configures the trust state for a class called class1 in a policy
map called policy1.
Console (config)# policy-map policy1
Console (config-pmap)# class class1
Console (config-pmap-c)# trust cos-dscp
Related Commands
set
set
The set Policy-map Class Configuration mode command sets new values in the IP
packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos}
no set
Parameters
• new-dscp — Specifies a new DSCP value for the classified traffic
(Range: 0-63).
• queue-id — Specifies an explicit queue ID for setting the egress queue.
• new-cos — Specifies a new user priority for marking the packet
(Range: 0-7).
Default Setting
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
Command Usage
This command is mutually exclusive with the trust Policy-map Class
Configuration command within the same policy map.
Policy maps that contain set or trust Policy-map Class Configuration
commands or that have ACL classifications cannot be attached to an egress
interface by using the service-policy (Ethernet, Port-channel) Interface
Configuration mode command.
To return to the Policy-map Configuration mode, use the exit command. To
return to privileged EXEC mode, use the end command.
4
QoS Commands
487