Configuring Vlan Rate Limit; Figure 3-123. Bandwidth Configuration Page - Alcatel OS-LS-6224 User Manual

Web – Click Policy, General QoS, Bandwidth Configuration. Define the fields, and
click Apply.

Figure 3-123. Bandwidth Configuration Page

CLI – The following is an example of the CLI commands used to configure traffic
shaping:
Console(config)# interface ethernet 1/e5
Console(config-if) traffic-shape 124000 96000

Configuring VLAN Rate Limit

Rate limiting per VLAN allows network administrators to limit traffic on VLANs. Rate
limiting is calculated separately for each unit in a stack, and for each packet
processor in a unit. QoS rate limiting has priority over VLAN rate limiting. For
example, if a packet is subject to QoS rate limits but is also subject to VLAN rate
limiting, and the rate limits conflict, the QoS rate limits take precedence.
Command Attributes
• VLAN – Indicates the VLAN on which the Rate Limit is applied
• Rate Limit – Defines the maximum rate (CIR) in kbits per second (bps) that
forwarding traffic is permitted in the VLAN.
• Burst Size – Defines the maximum burst size (CbS) in bytes that forwarding traffic
is permitted through the VLAN.
Web – Click Policy, General QoS, VLAN Rate Limit, and Add. Define the fields, and
click Apply.
Configuring Quality of Service
3
4-380
4-494
239