Alcatel OS-LS-6224 User Manual page 41

User guide
Hide thumbs Also See for OS-LS-6224:
Table of Contents

Advertisement

The auto-boot message that appears at the end of POST (see the last lines)
indicates that no problems were encountered during boot.
During boot, the Startup menu can be accessed if necessary to run special
procedures. To enter the Startup menu, press <Esc> or <Enter> within the first two
seconds after the auto-boot message is displayed. For information on the Startup
menu, see "Startup Menu Functions."
If the system boot is not interrupted by pressing <Esc> or <Enter>, the system
continues operation by decompressing and loading the code into RAM. The code
starts running from RAM and the list of numbered system ports and their states (up
or down) are displayed.
Note:
The following screen is an example configuration. Items such as addresses,
versions, and dates may differ for each device.
Preparing to decompress...
Decompressing SW from image-1
638000
OK
Running from RAM...
*********************************************************************
*** Running SW Ver. x.x.x.x Date 11-Jan-200x Time 15:43:13 ***
*********************************************************************
HW version is
Base Mac address is: 00:00:b0:24:11:80
Dram size is: xxM bytes
Dram first block size is: 47104K bytes
Dram first PTR is: 0x1200000
Flash size is: xM
Devices on SMI BUS:
-------------------
smi dev id = 16, dev type=0xd0411ab, dev revision=0x1
Device configuration:
Prestera based - Back-to-back system
Slot 1 - DB-DX240-24G HW Rev. xx.xx
Tapi Version: xx.x.x-x
Core Version: xx.x.x-x
01-Jan-200x 01:01:22 %INIT-I-InitCompleted: Initialization task is
completed
Console> 01-Jan-200x 01:01:23 %LINK-I-Up:
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-I-Up:
01-Jan-200x 01:01:23 %LINK-W-Down:
.
.
.
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-W-Down:
After the switch boots successfully, a system prompt appears (console>) and the
local terminal can be used to begin configuring the switch. However, before
e1
e2
Vlan 1
e4
e46
e47
e48
Booting the Switch
2
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents