Ip Igmp Snooping Multicast-Tv - Alcatel OS-LS-6224 User Manual

4
Command Line Interface
Use immediate leave only where there is just one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping leave-time-out 60
Related Commands
ip igmp snooping querier enable

ip igmp snooping multicast-tv

The ip igmp snooping multicast-tv Global Configuration mode command defines
the multicast ip-addresses that are associated with a multicast-tv VLAN. Use the no
form of this command to remove all associations.
Syntax
ip igmp snooping multicast-tv vlan vlan-id {add | remove}
ip-multicast-address [count number]
no ip igmp snooping multicast-tv vlan vlan-id
Parameters
• vlan-id — Specifies the Multicast VLAN ID.
- ip-multicast-address — Specifies the multicast IP address.
- number — Configure multiple contiguous multicast IP addresses. If
unspecified, the default is 1. (Range: 1-256)
Default Configuration
The default configuration has no multicast IP address associated with it.
Command Mode
Global Configuration mode
Command Usage
Use this command to define the multicast transmissions on a multicast-tv
VLAN. The configuration is only relevant for an access port, which is a
member in the configured VLAN as a multicast-tv VLAN. If an IGMP message
is received on such an access port, it would be associated with the
multicast-tv VLAN provided that one of the multicast IP addresses are
associated with the multicast-tv VLAN.
Bridge multicast filtering should be enabled prior to configuring this command.
Example
The following example configures a multicast ip address to a multicast-tv VLAN id.
Console(config)# ip igmp snooping multicast-tv vlan 1 add 10.6.80.99
418