Bridge Multicast Filtering - Alcatel OS-LS-6224 User Manual

4
Command Line Interface
Example
The following example adds a permanent static MAC-layer station source address
3aa2.64b3.a245 on port 1/e16 to the bridge table.
Console(config)# interface vlan 2
Console(config-if)# bridge address 3aa2.64b3.a245 ethernet 1/e16
permanent
Related Commands
clear bridge
show bridge address-table static
show bridge address-table count

bridge multicast filtering

The bridge multicast filtering Global Configuration mode command enables
filtering multicast addresses. To disable filtering multicast addresses, use the no
form of this command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Setting
Filtering multicast addresses is disabled. All multicast addresses are flooded
to all ports.
Command Mode
Global Configuration mode
Command Usage
If multicast devices exist on the VLAN, do not change the unregistered
multicast addresses state to drop on the switch ports.
If multicast devices exist on the VLAN and IGMP-snooping is not enabled, the
bridge multicast forward-all command should be used to enable forwarding
all multicast packets to the multicast switches.
Example
In this example, bridge multicast filtering is enabled.
Console(config)# bridge multicast filtering
Related Commands
bridge multicast address
bridge multicast forbidden address
bridge multicast forward-all
320