Configuring The Ast570 For Cip - Alcatel AST570 User Manual

12 Configuration and Use - CIP & IP Routing
12.2.5

Configuring the AST570 for CIP

Introduction
Configuration of the
AST570 'Phonebook'
page
Configuration of the
AST570 'CIP' page
136 / 300
After retrieving the LIS parameters, you must configure the
AST570, according to these parameters.
This section describes in short the global procedure for
configuring your AST570 'Phonebook' and 'CIP' pages.
By default the AST570 is configured for a CIP VC as used in the
example of section 12.2.7. If this VC is appropriate to your,
and/or the SP's needs, nothing has to be configured in the
AST570 phonebook.
If this VC does not match the requirements, three other CIP
phonebook entries are available to add.
However, in the case none of the entries match, you must add a
CIP phonebook entry yourself.
Adding phonebook entries is described in section 13.2.
The default CIP phonebook entry mentioned above is by default
configured for a LIS according to the example of section 12.2.7. If
this LIS configuration meets your requirements, nothing needs to
be configured, and your AST570 is ready for use.
However, if additional configuration is needed, you can configure
CIP members yourself.
The assignment of your CIP PVC to the CIP member can be done
implicit, or explicit, according the RFC1577/RFC2225 compliancy
of the remote access router.
Configuration of the AST570 'CIP' page is fully described in
section 12.4.
3EC 17766 AAAA TCZZA Ed. 04