Setting I/O Conditions - Omron ZG User Manual

Setting the Number of Digits Past the Decimal Point
Set the number of digits past the decimal point of the measurement value to output to the
Real-time Parallel Output Unit.
FUN mode-[I/O]-[RPD]-[DIGIT]
Setting value
5, 4, 3, 2, 1

Setting I/O Conditions

Switching Bank Data
Set from where switching of banks is to be instructed.
FUN mode-[I/O]-[I/O LINE]-[BANK]
Setting value
MENU
EXT IN
Setting the Measurement Trigger
Set the measurement timing method. The default setting is [DISABLE] (continuous
measurement).
FUN mode-[I/O]-[I/O LINE]-[TRIGGER]
Setting value
ENABLE
DISABLE
96
I/O Settings
Description
Sets the number of output digits past the decimal point.
(default value: 3)
Description
Bank switching is performed by operating the control keys. (default
value)
Bank switching is performed from the external input wire.
Description
The trigger is used as the measurement timing.
The trigger is not used and measurement is performed
continuously. (default value)
ZG User's Manual