Table of Contents
Advertisement
Profile Screen
A cross-section shape of the measurement object displayed on screen is called a
"profile." Profiles are displayed on screen as a yellow line.
In the RUN/ADJ modes, the measurement state can be visually checked by these
profiles. Also, in the FUN mode, profiles can be used to set the measurement conditions.
Height measurement items are already set as the default, so it is possible to know
immediately the detection status of the Sensor by setting the operation mode to the RUN
mode.
On the ZG series, measurement points in the height and width directions are measured
on the vertical (Z-axis) and horizontal (X-axis) axes, respectively. Measurement values
are displayed as numerical values prefixed with a + (plus) or - (minus) sign depending on
the coordinate position.
NEAR
+5.00 mm
0
-5.00 mm
FAR
ZG User's Manual
Z-axis +
X-axis -
Z-axis -
Overview of Settings and Measurement
X
X-axis +
37
Advertisement
Table of Contents
