Table of Contents
Advertisement
Setting the Connection Port
1
Select [Settings]-[Control Panel] from the [Start] menu in the PC and double-click
[System].
The [System Properties] dialog box is displayed.
2
Open the [Hardware] tab and click [Device Manager].
The [Device Manager] dialog box is displayed.
3
Open [Ports (COM&LPT)] and check the COM number in "OMRON Smart
Sensor USB COM Drivers (WDM) (COMxx)".
"(COMxx") indicates the Controller's connection port.
4
Select the Controller's connection port from [COM Port], and click the [Set]
button.
Warp Engine ZS starts up.
200
Updating the Firmware
If startup of Warp Engine ZS fails, a
message is displayed, followed by the dialog
box shown below.
ZG User's Manual
Advertisement
Table of Contents
